The Panhard Correction kit from Eimkeith is designed to eliminate the need for an adjustable panhard bar to recenter the axle and return the suspension on lifted vehicles to it’s original geometry....
*Sold in pairs*
So have you seen photos of cracked strut towers on 1st Gen Tacomas or 3rd Gen 4Runners?
These reinforcement plates are made to strengthen the strut tower and prevent this cracking...
If you’re wheeling your 4Runner (or FJ, or GX, or 80-Series LandCruiser) you’re eventually going to beef up your rear axle links. Then, due to the extreme angles they find themselves in, those bee...
Note: 1st Gen Tacomas will require slight clearancing to the sway bar bracket to use the kit
After seeing multiple incidences of failure at the ball joint end of the factory 3rd gen 4Runner lower ...
So you have your LLS (Lower Link Mount Reinforcement Skids) welded on and you’re good to go, right? Yep.– Until you twist and tear your axle side upper link mount!
To combat this, eimkeith mad...
Want to run the F-150 fuel tank on our 3rd Gen 4Runner? Don't waste your time trying to mount it yourself! Just grab this kit from Eimkeith!
These were designed to tuck the tank up in between the f...
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.
