Note: 1st Gen Tacomas will require slight clearancing to the sway bar bracket to use the kit
After seeing multiple incidences of failure at the ball joint end of the factory 3rd gen 4Runner lower ...
Our HD Rear Links are engineered to provide maximum protection against damage, maximize travel, increase rear axle articulation, and correct rear axle alignment when installed on lifted trucks a...
Our Panhard bar correctly re-center’s the axle, correcting is factory position after a lift has been installed; as well as significantly increasing its strength. Ideal for trucks with 2-3.5″ lift...
Save $25 when bought as a complete set vs purchasing individually!
Our Full Rear HD Link and Panhard Bar Set is engineered to provide maximum protection against damage, maximize travel, increas...
Replaces OE Rear Panhard Rod, adjustable to suit lift height
Zinc plated steel and E-coated with high quality rubber bushes supplied
Off-car adjustable, cannot be set while fully installed
For 35...
Comes with high quality rubber OE style bushings installed for maximum flexibility, and zero noise
Made from HSLA (High Strength Low Alloy) Steel, 40mm OD and 6mm wall thickness with support brac...
Replaces OE Rear Panhard Rod, adjustable to suit lift height
Zinc plated steel and E-coated with high quality rubber bushes supplied
Off-car adjustable, cannot be set while fully installed
For 45...
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.
